Configuring DHCP server for YSoft SafeQ Client autodiscovery
This article is about the configuration of DHCP server for YSoft SafeQ Client autodiscovery. Set the DHCP option 9 (LPR Server) to one or more IPv4 addresses of SafeQ server(s) for every location where autodiscovery based on DHCP will be used.
Setting up DHCP server requires expert knowledge about system configuration and networking. If you are not familiar with this topic, request assistance from appropriate person.
Setting of DHCP vary among operating systems and solution used. Following guide apply for Windows Server 2008's DHCP service.
1 | Log in to the Windows Server where DHCP is configured and run Server Manager.
|
2 | Expand Roles > DHCP Server > %Server_name% > IPv4, where %Server_name% is identification of your DHCP.
|
3 | Expand your Scope, right-click Server Options and select Configure Options... .
|
4 | Navigate to option 009 LPR Servers and add IP address(es) of SafeQ server(s) for given location. |
5 | Repeat the procedure for every location.
|
