ORS - How to change the GUID of ORS server
This chapter describes steps required for changing of the ORS GUID.
WARNING: GUID = Unique identifier of server.
Before you change the GUID to a new one, be sure that the same ORS GUID in NOT already present in your YSoft SafeQ environment.
Configuring ORS to use the new GUID
1 | Verify the orsCacheRecovery attribute is enabled in the CML settings. Open YSoft SafeQ Web Interface => System => System settings => In the Expert View set orsCacheRecovery to enabled
|
2 | Open the Services window (e.g. Start => Run => services.msc) and stop all YSoft SafeQ ORS services:
|
3 | Edit <SafeQORS>\conf\modules\guid.conf file and enter new ORS GUID in parameter localGUID: localGUID=%NEW_ORS_GUID%
|
4 | Open web interface of YSoft SafeQ CML server (use the first node in case of CML cluster) and go to Devices => Printers. |
5 | Edit ORS server where the GUID has changed.
|
6 | Replace value at Spooler GUID by the new one (the same value which was used in guid.conf).
|
7 | Delete ORS cache by deleting folder <SafeQORS>\server\cache .
|
8 | Open the Services window (e.g. Start => Run => services.msc) and start all YSoft SafeQ ORS services:
|
9 | Verify the correct ORS functionality according to the article YSoft SafeQ ORS Health Check. |
If you omit this step, all jobs stored on this ORS will be lost at the end of procedure.
