Devices which supports YSoft USB reader

USB card reader is supported on following devices with eB-X Platform.

A4 models:
e-STUDIO287CS / e-STUDIO347CS / e-STUDIO407CS
e-STUDIO477s / e-STUDIO527s

A3 models:
e-STUDIO2040C / e-STUDIO2540C / e-STUDIO3040C / e-STUDIO3540C/ e-STUDIO4540C
e-STUDIO2050C / e-STUDIO2051C / e-STUDIO2550C / e-STUDIO2551C
e-STUDIO2555C / e-STUDIO3055C / e-STUDIO3555C / e-STUDIO4555C / e-STUDIO5055C
e-STUDIO5540C / e-STUDIO6540C / e-STUDIO6550C
e-STUDIO256 / e-STUDIO306 / e-STUDIO356 / e-STUDIO356 / e-STUDIO456 / e-STUDIO506
e-STUDIO656 / e-STUDIO756 / e-STUDIO856
e-STUDIO306 LP

On the latest MFP FW the YSoft USB card reader is already preregistered, so the registration procedure is not required for proper working of the USB card reader. On the older MFP FW the YSoft USB card reader must be registered to the device manually.

Please see the following table regarding MFP FW version:

Device	MFP FW version supporting registration	MFP FW version with already preregistered Y Soft USB card readers
e-STUDIO287CS / e-STUDIO347CS / e-STUDIO407CS e-STUDIO477s / e-STUDIO527s	The first firmware already supports this function	The first firmware already supports this function
e-STUDIO2050C / e-STUDIO2051C / e-STUDIO2550C / e-STUDIO2551	Higher than 1510	Higher than 1510
e-STUDIO2555C / e-STUDIO3055C / e-STUDIO3555C / e-STUDIO4555C / e-STUDIO5055	The first firmware already supports this function	The first firmware already supports this function
e-STUDIO2040C / e-STUDIO2540C / e-STUDIO3040C / e-STUDIO3540C/ e-STUDIO4540C e-STUDIO5540C / e-STUDIO6540C / e-STUDIO6550C	Higher than 3404	Higher than 3404
e-STUDIO256 / e-STUDIO306 / e-STUDIO356 / e-STUDIO356 / e-STUDIO456 / e-STUDIO506 e-STUDIO656 / e-STUDIO756 / e-STUDIO856	Higher than 1604	Higher than 1610
e-STUDIO306 LP	The first firmware already supports this function	The first firmware already supports this function

Note

It is reccomended to update your device's FW to the latest version. Latest FW versions already have YSoft USB card reader preregistered, so it is not required to perform registration procedure.

YSoft USB card reader registration chapter must be done when the Toshiba MFP FW is lower version than FW which has YSoft USB card reader already preregistered. More information about the registration can be found in the article configure Toshiba device to work with YSoft USB card reader.

Toshiba device configuration

1) Navigate to Toshiba service menu and set 3500 (write this number and press green Start button) to "60001".

2) Connect the USB reader to the MFP.

3) Reboot the MFP.

Note: Turn the power OFF before connecting the device. If you do not, the device may not be correctly recognized. In that case, reboot the MFP with the device connected.

YSoft USB card reader settings

The USB card reader has to be set to the USB keyboard mode. When a different one is set, use the usbrdrtool to change it.