Xerox Multifunction Printers with Samsung controller
The following multifunction printers with a Samsung controller have already been certified.
Phaser 3635 (reviewed against Firmware version 20.105.47.000 June 2015)
This manual was created based on Xerox Phaser 3635 and should be applicable to most MFPs with Samsung controller, although slight differences may occur.
Before installation of YSoft SafeQ Embedded Terminal
Time configuration
At the printer control panel, press the Machine Status button and switch to the Tools tab. Note: you my need to be logged on as the devise Admin account to perform these settings. Then touch Device Settings > Common Service Settings > Machine Clock/Timers.
Custom Services
Go to the Properties tab > Services > Custom Services and do the following settings:
SSL
Create a new secure certificate and enable SSL.
Go to the Properties tab > Security > Machine Digital Certificate and check Installed Certificates. When a certificate is not created, create new Self signed certificate.
Then go to Connectivity > Protocols > HTTP and enable the SSL.
Note that you have to reload the page after you enable SSL if it was disabled before. Next time, you will be redirected to secured page (https). Also remember you have to recreate the certificate if you change the IP address of the device, as the certificate is IP-relative.
Network Accounting
Go to MFP panel and log in as admin, then go to Tools > Accounting > Accounting Enablement > Authentication Mode, choose Network Accounting and save the settings.
Then go to Network Accounting Setup > Network Accounting Authentication and Disable authentication.
Save all values and log out from the menu.
Authentication
Go to the Properties tab > Security > Authentication > Authentication > and choose Require Network Authentication and other required options:
SNMP
You will later need to fill proper SNMP community in device configuration. You can check current MFP setting under the Properties tab > Connectivity > Protocols > SNMP.
Click Edit and set community names accordingly:
Scan Services
Go to the Properties tab > Services > Network Scanning > Scan Template Management and select the enabled check-box.
USB Card Reader
Go to the MFP panel and log in as admin, then go to Tools > User Interface > General > SFO and enable 35 and save.
Proceed with the MFP installation in SafeQ to complete the installation of YSoft SafeQ Embedded Terminal. Check the installation status and installation steps.
If there are some warnings present during the installation, you will need to do some further settings based on the messages.
After installation of YSoft SafeQ Embedded Terminal
Device and Service Access
This feature is unavailable on this MFP.